ooooooooooo

What Did You Do To Your Roxor This Weekend?

plumbstraight

Active member
Joined
Jan 31, 2020
Messages
271
Points
43
Location
georgia
Roxor Ownership
Roxor Owner
Roxor #
3171
Carpeted my cab and doors. Had enough left over to make mats for the floors.
 

plumbstraight

Active member
Joined
Jan 31, 2020
Messages
271
Points
43
Location
georgia
Roxor Ownership
Roxor Owner
Roxor #
3171
I went in to have a bite and someone lifted my phone. Lost all my pics
 

Spanky

Active member
Joined
Apr 15, 2019
Messages
272
Points
43
Location
Jackson, AL, USA
Roxor Ownership
Roxor Owner
Roxor #
717
Hers a few pics of the rear bumper I started.

20210428_112632.jpg 20210428_112637.jpg 20210428_112645.jpg
 

CJ2Rox

Well-known member
Lifetime Member
Joined
Oct 30, 2020
Messages
808
Points
63
Location
Plymouth UT, USA
Roxor Ownership
Roxor Owner
Roxor #
6475
Now seal it up and make it airtight and use it to add air to tires if needed! Hook it to a compressor pump that runs off engine or you could have a train horn...lol
 

txroadkill

Well-known member
Joined
Oct 28, 2018
Messages
1,109
Points
113
Location
Texas
Roxor Ownership
Roxor Owner
Roxor #
2498
I wish we could get the compressor bracket from the factory ac to do an onboard air. So far I haven’t seen a part number to order just the mounting bracket.
 

Roxor76028

Member
Joined
May 5, 2021
Messages
26
Points
13
Location
Burleson, TX, USA
Roxor Ownership
Looking to buy
Well, it's been a busy week. Completed the following;

Spartan Rear Locker
KYB Shocks
MileMaker 481 Locking Hubs
Changed All Fluids
Adjusted Clutch
Tightened Power Steering Belt
Cut Factory Front Bumper (Picture)- Was rubbing with new tires.
Dirt Legal Fender Flares
1.25" Wheel Spacers
Climax 1.5" Leveling Shackle
Installed 235/85r16
Removed Front Sway Bar
Greased 8 factory zerks
Tightened bolts, still have a small pop up front.

To Do: EGR delete & intake hold down to install. Would like to add a Trash-a-roo & rear center caps for CJ. It's been a fun project. No way could I have done it without this forum.

You guys are awesome! Time for some summer fun....

20210515_154755.jpg 20210515_154722.jpg
 

Roxasuras

Well-known member
Lifetime Member
Joined
Mar 10, 2019
Messages
2,092
Points
113
Location
Hurricane, WV, USA
Roxor Ownership
Roxor Owner
Roxor #
2507
Installed some factory sway bar bolts(notified for quick disconnect) I hope:unsure:. Time shall determine.

0516211532_HDR.jpg
 

plumbstraight

Active member
Joined
Jan 31, 2020
Messages
271
Points
43
Location
georgia
Roxor Ownership
Roxor Owner
Roxor #
3171
Rather than cut my bumper I have the thinking of using a 4in pipe with extentions from the frame. Would give room for the tires and protection for the fenders.
 

Vinny

Well-known member
Supporting Member
Joined
Jun 13, 2019
Messages
359
Points
63
Location
Prescott, AZ, USA
Roxor Ownership
Roxor Owner
Roxor #
02776
I don't need no stinkin tractor! ? Bought a Swisher pull behind mower, installed the trailer hitch and Boom, mowed the property. The little guy chugged along at 5mph for 2 hours. I want to thank the folks on this forum (Bister) for guiding me to the right hitch. Being a cheap a--, I was ready to buy the least expensive hitch. Saw the comments from folks that bought the one I was looking at, then saw the advice from Bister.
No regrets!(y) Thanks Mr. B.

20210517_152247.jpg 20210517_152228.jpg
 
Top