OFFICIAL: What did you do to your Roxor today?

[USMC]

Ok Vinny and Rox, I went online and found Maps for those designated sites that you two are talking about. I am sure we could find all kinds of treasures there. The maps are only $120.00 each. Are you two in?

 

[Vinny]

Ok Vinny and Rox, I went online and found Maps for those designated sites that you two are talking about. I am sure we could find all kinds of treasures there. The maps are only $120.00 each. Are you two in?

Not sure what areas. Only treasure I could think of in Houston would be oil.😁😁

 

[Roxasuras]

I don't know of any treasure at the Marion County Landfill

 

[Wilburr]

I installed Mike marker hubs today

Sent from my iPhone using Tapatalk

 

[Kid Rox]

OTR 2.5” shackle reversal level, 1” shackle lift in rear and 35x10x17 sx2 from marketplace off an old cj. Pretty happy with the set up but I will have to add spacers up front due to rubbing on leafs

 

[Roxasuras]

Looks nice

 

[Wilburr]

OTR 2.5” shackle reversal level, 1” shackle lift in rear and 35x10x17 sx2 from marketplace off an old cj. Pretty happy with the set up but I will have to add spacers up front due to rubbing on leafs
View attachment 14778

What are the details on your rims?


Sent from my iPhone using Tapatalk

 

[Kid Rox]

Looks nice

Thank you

What are the details on your rims?


Sent from my iPhone using Tapatalk

They are American racing AR201’s I believe. One piece aluminum.

 

[Kid Rox]

Got new shocks, bulkhead and roof installed despite the chilly weather, and of course had to take it for ride to test out the new upgrades.

Is it just a optical illusion or is your break line pinched on the axle?

 

[USMC]

I would go with an optical illusion. It looks like the angles of the brake line fused from the position of the camera.

 

[Wilburr]

Installed the diesel freaks heim steering kit.

Sent from my iPhone using Tapatalk

 

[Gabe]

What does the stering kit do? I have not noticed that much issue with the stering.

 

[Wilburr]

What does the stering kit do? I have not noticed that much issue with the stering.

I had one of my joints that was in bad shape and I had seen that this was a lot heavier duty steering linkage so I decided to change out everything. It did require drilling out the pitman arm and knuckles with an included bit. But if it aint broke don’t fix it!


Sent from my iPhone using Tapatalk

 

[SteveinUT]

Finally got around to putting a 2m/440 radio in the Rox.

 

[Roxasuras]

Where did you mount your antenna

 

[SteveinUT]

Where did you mount your antenna

On the back, right side of the tub. I'll take a pic when I get home and post it up as well.

 

[SteveinUT]

Here is the antenna. Just a standard L-bracket NMO mount with SS hardware.

 

[Roxasuras]

Nice, I put mine on the bumper, same side.

 

[Roxasuras]

I like the tire cover

 

[USMC]

New Non-Locking latch for the driver's seat box and the new bolt on receiver hitch.

For a while these receiver hitches were not available, and I was going to fabricate my own. I like this receiver because it is rated for the advertised tongue weight of 349 lbs., and the towing capacity of 3490 lbs. These are the max capacities for the Roxor per Mahindra. I have seen other receivers but at lower capacities.

I need to tighten all the bolts yet. Anyway, On The Rox provided 4 extra larger diameter bolts. I will go get the proper flange nuts and swap out 4 of the smaller bolts for these larger diameter bolts.