ooooooooooo

OFFICIAL: What did you do to your Roxor today?

Govey500 SweeperCar

Member
Lifetime Member
Joined
Dec 4, 2023
Messages
21
Points
13
Location
Government Camp, Oregon Mt. Hood
Roxor Ownership
Roxor Owner
I installed Mike marker hubs today
111bf65e84e0022df3b7fdf7b2d1743b.jpg



Sent from my iPhone using Tapatalk
No no no, it's Mile Marker, Mike is the younger brother and he makes specific signs for state agencies. Those signs are called mile markers ... LOL, ok ok ok, I am sorry, I am only kidding, I shouldn't have coffee in the afternoon! On the serious side, I have the same ones and I am very happy with them. I used them a lot this winter going from elevation to sea level so they got their workout! Enjoy
 

USMC

Active member
Joined
Jul 1, 2024
Messages
211
Points
43
Location
Naples Florida
Roxor Ownership
Roxor Owner
Roxor #
09848
Ok, I just finished upgrading the four bolts, tightening the receiver hitch, and then putting the trailer hitch on. Almost a perfect fit.

The # 10 bolts went in fine on the left. On the right side (passengers) I had to drill the frame holes out slightly. Anyway, the hitch receiver is fully tightened, and the trailer hitch is on, and it looks fine with my extended spare tire carrier.

20250525_134830.jpg 20250525_131008.jpg 20250525_134750.jpg
 

BAM

New member
Joined
May 22, 2024
Messages
16
Points
3
Location
Montana
Roxor Ownership
Roxor Owner
I didn’t do this today but thought I’d still share. Bought this trailer box from Harbor Freight for $120 I believe and bolted it to the bed behind the rear seat. Fits perfectly and allows the gate latch on the rear door to close. Couldn’t have fit any more perfectly.

IMG_8462.jpeg IMG_8463.jpeg
 

lost1wing

Active member
Lifetime Member
Joined
Dec 29, 2023
Messages
177
Points
43
Location
Georgia
Roxor Ownership
Roxor Owner
Roxor #
10480
New Non-Locking latch for the driver's seat box and the new bolt on receiver hitch.

For a while these receiver hitches were not available, and I was going to fabricate my own. I like this receiver because it is rated for the advertised tongue weight of 349 lbs., and the towing capacity of 3490 lbs. These are the max capacities for the Roxor per Mahindra. I have seen other receivers but at lower capacities.

I need to tighten all the bolts yet. Anyway, On The Rox provided 4 extra larger diameter bolts. I will go get the proper flange nuts and swap out 4 of the smaller bolts for these larger diameter bolts.

View attachment 14822 View attachment 14823 View attachment 14824
I need to remove those darn locks too.
 
Top