DIY Metal Doors

[jcyphert]

 

[ranchonodinero]

Perfect! I believe I have a powder coat lined up. Thanks again!

 

[Bob R1]

If you would, send me the file also.

twobugs70@gmail.com

Bob R

 

[Bgodwin]

Can you send a copy of the file please? M.blake.godwin@gmail.com

 

[RetColTom]

If anyone with a plasma table needs the dxf for the doors, let me know. I knew the color match would be off from the paint store so I went sand colored.

View attachment 13213 View attachment 13214 View attachment 13215 View attachment 13216 View attachment 13217

Can you send dxf please?
Thomas.a.fitch@gmail.com
Thank you.

 

[DDP70]

Thanks so much for sharing this info! If you are still sending out the file my email address is

douglas.powers1@gmail.com

 

[RoxinatorAZ]

Send also, and thanks.

greg.dayley@tempeautogroup.com

 

[Bob R1]

If you get time, it would be nice if your Half Doors were set up to take the Jeep YJ Wire Frame removable Upper Canvas Door Halves that mount to YJ Metal Factory Half Doors. We still have several YJ's running around in my area with factory Metal Half Doors. They have a 3/8" Wire Frame and Three Wire Pegs that drop into holes on the YJ Jeep Metal Half Doors. Best Top and at least one other company still makes the Canvas upper door section. They come with and without the Frame.
If this could be made to work, it sure would make closing in a Roxor much easier. Even if one had to fabricate a filler section for the area behind the door to the roll bar.
I am planning to try and locate a used set someone has changed out, or has for a spare set, and see what would be required to make them fit on a Roxor Half Door. If the front door to windshield angles are ok, this should be a doable build.
Think about it a little.

Bob R