AZROX
Well-known member
@SMF: just as you did, I reused the factory gaskets on one Roxor and used the ones DF provided on the other. I also used the OTR bracket (picture below) because I had ordered it some time before I ordered the DF kit - never installed it until last week. It was too long ago to return the OTR bracket.
@Max A and @SMF
thanks for comfirming you are using hold down brackets with the DF kit.
Max A. thanks for confirming that you had to slightly modify the factory hold down bracket. I will do that in fall when I use all of the DF kit.
In addition to the factory hold down bracket, I also have the OTR hold down installed. Belt and suspender. This is the OTR bracket.
I can use the OTR bracket as long as I am keeping the factory top piece (steel, 2" inlet). The picture Max A attached, shows he uses the top piece from the DF kit (aluminum, 2.25" inlet). It does not have the eyelet (red circle in the picture). Max A. is also using the factory hold down bracket.
...Since I no longer see a Preview Button, I hope the pictures land in the intended locations.....
@Max A and @SMF
thanks for comfirming you are using hold down brackets with the DF kit.
Max A. thanks for confirming that you had to slightly modify the factory hold down bracket. I will do that in fall when I use all of the DF kit.
In addition to the factory hold down bracket, I also have the OTR hold down installed. Belt and suspender. This is the OTR bracket.
I can use the OTR bracket as long as I am keeping the factory top piece (steel, 2" inlet). The picture Max A attached, shows he uses the top piece from the DF kit (aluminum, 2.25" inlet). It does not have the eyelet (red circle in the picture). Max A. is also using the factory hold down bracket.
...Since I no longer see a Preview Button, I hope the pictures land in the intended locations.....