Roy
New member
- Joined
- Mar 17, 2019
- Messages
- 3
- Points
- 1
- Location
- Elko, NV, USA
- Roxor Ownership
- Roxor Owner
- Roxor #
- 1001
I just received my new Roxor at the mine site I'm at. To make it underground worthy I needed to install a strobe. I used the power from the pre wired side/rear led harness/connector and ground wire. After I did this I lost all function of my gague save for back light and battery light on initial start up. If I disco both connectors, wait 5 min and plug them in the speed needle cycles around and "Mahindra" flashes then nothing. *side note( I took it underground despite the gauge issue, came back to surface, washed it down and it would loose power when accelerating. I disconnected the speed sensor and it works fine.) Please help.