ooooooooooo

front end noise

tshelton18

New member
Joined
Apr 30, 2020
Messages
6
Points
1
Location
Rye, TX, USA
Roxor #
02966
Roxor Ownership
Roxor Owner
I just got a 2019 and its starting to make a rubbing grinding noise on my front end and ideas what it could be? I can hear it and fill it. after stopping or even slowing down it will stop.
 
Wheel bearings. take it in for warranty.
 
Just changed wheel bearings and it’s still making the noise and grinding. Differential? Front-end?
 
put it up on good jacks with it stable. Run in gear and listen to where it is coming from. I would tie it down for sure. May just be a rock caught in the brakes.
 
The noise was coming from the right spindle bearing/brass bushing. I just didn’t go in quite deep enough on the bearing!
Also, there are grease zircs on the rear wheels that we didn’t know about!
 
zerks. Two on the sides that are easy to see. One on each drive shaft and the two on the rear wheels that you found.
 
If you use Facebook, join one of the roxor groups. There's a lot of good info there.
 
There’s 8 zerks. 4 spring bolts. 2 driveshaft slip joints and the 2 outer wheel bearings on rear axle.


Sent from my iPhone using Tapatalk
 
@Partyman1971: you mention "two on the sides that are eaay to see". Where exactly are these two zirks? Is it one of these? If not, just add to this list.
I am aware of zirks at:
- 2 leaf spring bolts, front axle
- 2 leaf spring bolts, rear axle
- 2 rear axle bearings (1 left, 1 right)
- 1 drive shaft, front
- 1 drive shaft, rear
Thats all of them I believe. Sorry I wasn't accurate.
 
Where are the ones on the rear axle? Picture?


Sent from my iPhone using Tapatalk
 
Anyone? Are they behind the center cap?


Sent from my iPhone using Tapatalk
 
Thanks to both of y’all. Found it and greased. Took lots of grease for it to come out of fill hole. Must of been dry
2be47ece52977ded13c8daf7597d54a6.jpg



Sent from my iPhone using Tapatalk
 
Back
Top