ooooooooooo

Emergency Brake Cable

Joined
Feb 8, 2023
Messages
66
Points
18
Location
Billings Montana
Roxor Ownership
Roxor Owner
My short cable broke last year, pulled the tit right off the cable at the lever. My half seized long cable did not help. I replaced both cables.

I keep them in stock and they are not too difficult to change.


 

lost1wing

Active member
Lifetime Member
Joined
Dec 29, 2023
Messages
179
Points
43
Location
Georgia
Roxor Ownership
Roxor Owner
Roxor #
10480
I saw this today and thought I would ask. I am having to pull the brake handle quite a bit further than when it was new. I had help doing some winching and found out they were using the hand brake. They pulled it as hard as they could. I can not see a broken or stretched out cable. Where is the cable braking?

On another related note, I felt as if the brake is set when the handle is down. Cables were loose so I thought that one of the brakes were stuck. After jacking and spinning each wheel easily, I don't understand the drag when coasting to a stop. Bad bearings are showing with the weight of the vehicle since they spin easy on jacks?
 
Joined
Feb 8, 2023
Messages
66
Points
18
Location
Billings Montana
Roxor Ownership
Roxor Owner
There is an adjustment under the cab to take up some cable stretch. Mine Pulled the lead tip from the lever in the cab.

Bad bearings will definitely make brakes lock up differently when on jack stands, and these cables are susceptible to seizing from getting dirt in.
 

lost1wing

Active member
Lifetime Member
Joined
Dec 29, 2023
Messages
179
Points
43
Location
Georgia
Roxor Ownership
Roxor Owner
Roxor #
10480
I may have to pull the rear drums and look. I'm taking the front apart next to install locking hub assy's.
 
Top