Latest activity

I have a 22’ for sale too.

Where did you get your plates and I dont under stand what you have to weld

Yeah, too far for me to ship. I did get a fender from diesel freak. I don't think the hood would be terrible to get, in the parts...

I have a front clip that you're looking for - but I'm on the other side of the country (Washington State)

This is an old thread. If you are still looking, try this: Cabin+Heater+Kit+(4+Hole).pdf

@TheFurnace is this still available for sale?

That "mint" jeep tub looked like it had been fragged by a 155mm howitzer. Holes in looked like the milkyway. If I do get to reclaiming...

I have been contemplating buying a Roxor. I live on the Western edge of Minnesota, so going to SD to get the motorcycle plate would be...

In the front you will need locking hubs installed to be happy with a locker. In the rear it will depend on where you drive. I drive on...

I am robbing parts off a rusted out YJ to put on the Roxor. I lucked out, the Windshield Frame was not rusted out on the Jeep. The Glass...

Nice Picture and Green Grass, a good combination for December. Looking like it will warm up again next week. Bob R

Hey Plumbstraight, KaiserWillys has tubs galore! @ Homepage

I’m in FL and went through Dirt Legal with no issues, the process was pretty straightforward. For the smaller plate, I’m using a...

Very nice [emoji106] Sent from my iPhone using Tapatalk

I finally came up with an modification that no one else on here has posted....I think. So after a few rides after dark and dealing with...