KFI Plow Lowering Brackets for Lifted Roxors

[jcyphert]

I ordered the KFI 62" plow for my Roxor, but after mounting it, I realized the lift kit was affecting the plow’s angle of approach. The issue was especially bad when angling the plow—one side would be nearly 10 inches off the ground while the other touched down. This happened because the Roxor’s pivot point was higher than what the plow was designed for.

To fix it, I cut new 3/8" brackets on the plasma table and lowered the mount by 6 inches. No modifications were needed to the original KFI components—just remove the factory ears and install the new ones!

This KFI is a great plow, by the way. I especially like the 2" receiver they added to the mount plat on the roxor. It will be great for a Clevis Shackle for use with a snatch block

 

[Wilburr]

It rarely snows where I live so I don’t think I’ll ever have to worry about it but with the size weight of the roxor how does it do snow plowing?


Sent from my iPhone using Tapatalk

 

[jcyphert]

Haven't had any heavy shows yet, but very well so far

 

[Ckreklau]

Minnesota here, we get snow but hopefully not until next fall...I have had my KFI 72" plow for a few years now on a Cub Cadet Challenger 750 (2020ish). 100% good plow, but first year hooking it up to the Roxor. Connected perfect on the new bracket/attachment kit, need a little longer lead for electrical as I have the Left/Right tilt angle on mine. There are adjustments you can make on the plow for height/tilt of the vehicle your using it with, also feet (snowcones) that prevent the blade from digging into the dirt or your driveway. Also able to change the angle of the plow up/down to a set point, pretty easy to setup when it is installed. do it on a level surface

 

[jcyphert]

There are adjustments you can make on the plow for height/tilt of the vehicle your using it with, also feet (snowcones) that prevent the blade from digging into the dirt or your driveway

Those were not enough of an adjustment on my plow for this angle. Hence the bracket

 

[Ckreklau]

Those were not enough of an adjustment on my plow for this angle. Hence the bracket

understood. how tall of lift did you put on yours if you don't mind me asking? Questioning my decision for installing one on mine now.

 

[jcyphert]

It was the rough county leaf over kit. I think it raised 5" plus tire size lift

 

[Ckreklau]

did you need to cut fenders or anything for turning clearance with everything installed? Sorry for all the questions, just trying to figure out what I should do with mine. Thanks!

 

[jcyphert]

did you need to cut fenders or anything for turning clearance with everything installed? Sorry for all the questions, just trying to figure out what I should do with mine. Thanks!

I trimmed the inside corners of the front bumpers a little. Looks better now. I'll try to post a picture later