USMC
Active member
- Joined
- Jul 1, 2024
- Messages
- 280
- Points
- 43
- Location
- Naples Florida
- Roxor Ownership
- Roxor Owner
- Roxor #
- 09848
I was trying to get grille dimension information from KaiserWillys but it went no where.
I just found this site that some of you may use. It is www.jeepdatabase.com
I hope anyone finds this site helpful!
My OEM 2022 Grille Dimensions are 19 1/2 inches tall x 54 inches wide x 6 1/2 inch headlights. I will now check to see which OEM grille may work on the Roxor. These measurements are based on the way the grilles were measured on www.jeepdatabase.com
Looking at all the dimensions the Jeep FC 150 appears to be the closest specs to the 2022 plastic Roxor Grille. The FC grille is 1 inch shorter and you would need to add a bezel or trim ring for the headlight. I may buy one if KaiserWillys has one available.
Actually on the FC-150, that is one Ugly Grille!
Ok, Looking at all the specs, I think that the M151 Grille would be the easiest to convert to the newer Roxors. The caveat, the M151 had the horizontal slots and not the vertical slots. Cut the stock M151 grille down the center and add 8.7 inches. You may need to work on the bottom area also.
I just found this site that some of you may use. It is www.jeepdatabase.com
I hope anyone finds this site helpful!
My OEM 2022 Grille Dimensions are 19 1/2 inches tall x 54 inches wide x 6 1/2 inch headlights. I will now check to see which OEM grille may work on the Roxor. These measurements are based on the way the grilles were measured on www.jeepdatabase.com
Looking at all the dimensions the Jeep FC 150 appears to be the closest specs to the 2022 plastic Roxor Grille. The FC grille is 1 inch shorter and you would need to add a bezel or trim ring for the headlight. I may buy one if KaiserWillys has one available.
Actually on the FC-150, that is one Ugly Grille!
Ok, Looking at all the specs, I think that the M151 Grille would be the easiest to convert to the newer Roxors. The caveat, the M151 had the horizontal slots and not the vertical slots. Cut the stock M151 grille down the center and add 8.7 inches. You may need to work on the bottom area also.
Last edited:
