Engine quits

[jerry c]

I have 12 hours on mime now. So far it has quit 2 times. The fuel pump shuts off. If it sets for a few min it will start and run fine. Has anybody seen this before?

 

[TacoJon]

I have 12 hours on mime now. So far it has quit 2 times. The fuel pump shuts off. If it sets for a few min it will start and run fine. Has anybody seen this before?

No but you should have a 2 year/12,000 mi warranty. Get her in stat!

 

[jrobz23]

Def sounds like lift pump.

Fuel pressure is a gauge high on my list.

 

[Uncle Chuck]

I have about 4500 miles on my 2019 ROXOR. I have found that occasionally, when I accelerate hard and for an extended time, the engine dies. (Think about accelerating onto the freeway.) If I turn the key off, then start it again, it will keep going. This doesn’t happen all the time. I live about 1/2 mile from the freeway and I suspect that this only happens when I get in and take off immediately and the engine is not quite up to operating temp. Doesn’t seem to happen if I’ve already driven a few miles.
Anybody got any ideas?

 

[Roxasuras]

I have not had an issues with mine, wonder if it might be a dirty fuel pump

 

[jrobz23]

I have not had an issues with mine, wonder if it might be a dirty fuel pump

This. I have about 14,500 miles on mine and not one peep from my engine.

 

[Uncle Chuck]

Thanks guys! I’ll check it out. I have a scan gauge, but I don’t think it does fuel pressure.

 

[txroadkill]

Thanks guys! I’ll check it out. I have a scan gauge, but I don’t think it does fuel pressure.

They do but you might have to program your unit.

Scan gauge 2

I’ve had a scanguage2 in my old Jeep and kept it when I sold it. Great tool to have to read and clear codes as well as read data. I decided to hook it up to the Roxor. I used the adapter cable from dirt legal and velcroed the scanguage to the dash. Right now I can read rpm, mph, voltage, water...

teamroxor.com