echo3delta
Member
I installed a stage 2 ECM replacement and have had nothing but issues. I cannot keep it running, it will die while running down the road. If I unplug the ECM and plug back in I can limp it back home.
I swapped out back to the factory ECM until hopefully the aftermarket ECM vender makes it right.
My issue now is that I did an EGR delete and now with the stock ECM i have a check engine light. Does anyone have a workaroud for this? Plug in old sensors? Just run it? If I run it with the light on and EGR gone do I run a risk of damaging anything?
Any input is appreciated!
Sent from my LM-V405 using Tapatalk
I swapped out back to the factory ECM until hopefully the aftermarket ECM vender makes it right.
My issue now is that I did an EGR delete and now with the stock ECM i have a check engine light. Does anyone have a workaroud for this? Plug in old sensors? Just run it? If I run it with the light on and EGR gone do I run a risk of damaging anything?
Any input is appreciated!
Sent from my LM-V405 using Tapatalk